• Verify That The Thermostat

It’s worth checking if the thermostat is set correctly before concluding that the furnace is the cause. It’s also relatively easy to let the switch accidentally be moved and possibly during cleaning. Before you make any calls for heating repair in Irvine, CA, take time to ensure that everything is working correctly with your thermostat.

The thermostat should be set at a level that will activate the furnace. After setting it to the correct temperature, take a moment for the furnace and fan to start. If it’s not on, set the thermostat to 90 degrees Fahrenheit to ensure it doesn’t switch off and on while you attempt to resolve the issue.

• Replace The Filter

The heat exchanger may overheat and then shut down quickly when the filters are blocked by dirt and dust. It also leads to soot accumulation in the heating exchanger, which causes your furnace to run less efficiently.

The next thing to do is change the filter if the blower is operating but there is no heat flowing out. Flat filters should be changed every month at a minimum, and check pleated filters at least every month. Pleated filters generally last for three months, but according to our specialists for heating repair in Irvine, CA, you might need to change them more often if you have children or pets.

• Check That The Gas is Switched On

Like with the thermostat, it’s not difficult for the valve for gas to be closed and not be remembered. Check the gas line from the furnace to the meters to verify this. If you see an element parallel to the gas pipe, turn it so that it is parallel. A more old boiler or furnace is likely to have the pilot light. If it has the pilot light, you must remove the front panel and burner cover to determine whether it’s illuminated.

• Clean The Chimney Exhaust Flue

The problem could be bird droppings or debris inside the chimney exhaust pipe. To determine this, switch the furnace off and turn the thermostat to the lowest setting. Remove the duct and look for any debris. Remove leaves and other debris from the exhaust vents.

If your furnace exhausts outside your home, debris or leaves may block the exhaust or intake. If the pipes are covered with a screen mesh, change it with a half-inch mesh cloth.

• Clear The Drain Lines

During the winter, your furnace will remove several gallons of water daily. The furnace can stop functioning if the drain lines overflow with sediment or growth. Suppose you find an indication that your drain pipe is dirty; clean it out and then fill it up with chlorine and water. After the hose has sat for a few moments, wash it.